Dover ProGauge MagLink LX 4 - DIP-Switch Configuration

Connector Specification
L12 Input 3 status LED (Terminal 4)
L13 Input 2 status LED (Terminal 3)
L14 Input 1 status LED (Terminal 2)
L19 Relay 1 status LED (On = relay energized)
7.5 DIP-Switch Configuration
The illustration above shows the location of the DIP-Switch block on the Main Board.
The table that follows shows the configurations of the DIP-Switch:
Switch Number Description
1
Relay function Normal/Closed Under Power
OFF: Normal
ON: Closed Under Power
2
OFF = Internal inputs not available for alarms
ON = Internal inputs available for alarms
8
Enables Weights & Measures lock (W&M)
OFF: W&M disabled
ON: W&M enabled
M2050 MagLink LX 4 Installation Manual | Dover Fueling Solutions 24