US07 US08
Assembly ③
9
Note
・This concludes the assembly. Please confirm whether there is shaking, deformation, etc.
Then tighten all screws.
Tighten all the
screws firmly
⚠
8
・Fix the headrest and lumbar pillow as shown.
F
G
7
Installation of Armrest
・Attach the armrest to the main body as shown.
※ Please note the strength of screwing, if the backrest does not tip over, the armrest screws
may be too tight.
※ Armrest screws are stored in the screw pack.
N L
B
Function Description
Backrest Angle Adjustment Function
When adjusting the angle of the backrest, sit on the chair and operate the reclining lever.
・Pull the lever up to release the reclining function, and tilt it back to increase the angle of the backrest. lf it is the
other way around, it will decrease.
・Push the lever down to fix the backrest at the current angle.
Please note
●Do not apply backward force to the backrest until you have pulled the lever. This may cause structural damage.
When you adjust the backrest angle significantly, please support the backrest with your hand to avoid hitting
yourself with the rotation speed.
When using it for the first time, it may be difficult to adjust, please pull the lever upward vigorously once.
When you reduce the backrest angle
When you lie down
the reclining lever
reclining function
Precautions
●light weight people may have difficulty lowering the seat.
In that case,please sit on the seat and try a few more times.
raise the lift lever and lift your hips
raise the lift lever while sitting
raise the seat heightlower the seat height
the lift lever
height adjustment
To Next Page
Loading...