Doxmand VR1 - Troubleshooting

IMPORTANT! When charging externally from a baery, the device protects the baery from discharging, so if the baery voltage drops below the secruty level, the device automacally
disconnects it, charging stops, thus protecng the baery from excessive discharge.
If there is a protecve lm on the solar panel, it is advisable to remove it before using the product for the rst me, as aer a while the Sun may burn it, which can make it dicult to
remove and aect the proper energy consumpon!
3. CLEANING AND MAINTENANCE
IMPORTANT! Do not immerse the device in water! Do not use a strong detergent, abrasive scrubber to clean the appliance! Clean the device with a damp, so cloth. Over me, the solar cell
may become whish and become scale-coated, aecng the power supply of the device. It is therefore advisable to wipe it occasionally, for example by cleaning it with a recommended WD-40
or limescale cleaning agent.
4. STORAGE
IMPORTANT! When using the device periodically, please comply with the appropriate storage condions for longer lifeme! If the baery charge is too low or too high, you can shorten the baery
life. Its storage temperature is recommended between (-)20 and (+)25 °C. Always use the device o when not in use, in a closed environment!
Before pung it on the shelf, it is recommended to clean the device as described above. Check the baery charge! Turn it o and then on again to see how many beeps you hear when you turn
it back on. The device should be stored with a medium charged baery, so you should hear exactly 2 beeps when you turn it back on. If you hear exactly two beeps, turn it o and you can take
the device away.
If you hear 3 beeps, cover the solar panel while it is on and aer a few hours try to turn it on and o again. Repeat unl you hear 2 beeps when turning on. If you only hear one beep, put it to
the sun when it is turned on and let it charge. Aer a few hours try to turn it on and o again. Repeat unl you hear 2 beeps when turning on.
5. TROUBLE SHOOTING
Before contacng a service centre, please check the following opons:
PROBLEM POSSIBLE CAUSE POSSIBLE SOLUTION
The eect of the alarm is weakened.
Low baery level (1 beep).
The solar cell is not exposed to sucient sunlight.
The baery is only charged when the device is turned on!
It is recharged to the appropriate level with
sunlight, but if it sll gives you only 1 signal,
contact our customer service.
6. WASTE MANAGEMENT
Protect our environment!
Do not dispose of electrical equipment as household waste! Keep the packaging materials
out of the reach of small children as these may be dangerous to them! Collect the packaging
materials selecvely!
If electrical equipment is landlled, hazardous substances can leak into the groundwater,
causing damage to our health and well-being through entering the food chain.
7. DISPOSAL OF USED ELECTRICAL AND ELECTRONIC EQUIPMENT
Disposal of this product may be carried out in any electronic waste collector. Electrical
equipment may contain components that are hazardous to the environment.
The environmental is the heritage of our grandchildren, the preservaon of it
is therefore the common interest and responsibility of all of us, so I ask you to
help this endeavour!
EN
Changing between the modes is followed by sound signals so we can determine which mode is on:
- 1 beep: normal mode
- 2 beeps: silent mode
-
For the video manual please read the QR code below: