8
MINIATURE MICROPHONE
HEADBANDS
Adjusting the Type 4065 Headband
The Miniature Headband 4065 is pre-
formed for your convenience. However, it
requires minor adjustment in order to get
a tight, fixed position to the back of the
neck. Carefully bend the steel tube at the
areas shown on the illustration.
Note: Do not bend the steel tube near
the microphone element or near the
cable exit as you may risk breaking the
tube. The microphone element is per-
fectly omnidirectional and does not
need to point directly towards the
mouth of the performer. Avoid posi-
tioning the microphone in the air
stream from nose or mouth.
Do not bend near these parts of the
headband.
When bending the steel tube please treat
with care. The steel tube must be bent
around a curved object (min. diameter of
20mm) or a thumb in order not to break the
headband.
To Next Page
Loading...
