While holding down the (-) button, cycle through the lighting options by pressing the (Go) or (+) buttons until
only the bottom LED is illuminated.
Release the (-) button to confirm Stealth Mode.
To get out of Stealth Mode, simply repeat the above process and choose a different Lighting option.
Self Cleaning Cycle
The SWITCH is capable of cleaning your Ceramic Induction Cup by running a high energy heat cycle that burns
away any remaining residue in the Ceramic Induction Cup.
From any mode press and release the (+) button. (Will not work in Crystal mode)
Press and hold the (+) button until the Power Setting reaches maximum, continue to hold for 5 seconds
Release the (+) button once the front LEDs begin to escalate in Red. This indicates the high energy heat cycle
has begun.
The front LEDs will display the Power Setting increase, but will revert to the previously selected power setting
upon completion of the self cleaning cycle.
Press the (Go) button at any time to cancel the self cleaning cycle.
THE SELF CLEANING CYCLE IS SPECIFICALLY DESIGNED FOR CERAMIC INDUCTION CUPS AND SHOULD
NOT BE USED WITH A CRYSTAL INDUCTION CUP
DO NOT, UNDER ANY CIRCUMSTANCES, USE THE DEVICE WHILE IT IS IN THE SELF CLEANING CYCLE
Cleaning Your Switch
Be sure the SWITCH is powered off and that the Ceramic Induction Cups, glass top and Glass Percolator
Attachment are cool to the touch before cleaning.
The SWITCH unit, Induction Cups, Ceramic Filter, Glass Top, and Glass Percolator Attachment can be cleaned
with isopropyl alcohol and cotton swabs/wipes. Be sure all parts have dried completely before using the device
again.
The Dr. Dabber Crystal Induction Cup (sold separately) can be cleaned with isopropyl alcohol and a cotton
swab.
To Next Page
Loading...
