Charging and Battery Management
The SWITCH may be plugged into the charging unit at any time. The device uses pass-through charging
allowing use of the SWITCH while connected to the charging unit. (Note: The device will not function without
the battery pack installed)
Battery status is indicated on the front LED display after a Power Setting has been selected. The front LEDs
will illuminate Pink to represent the remaining battery percentage.
Pink flashing lights indicate the battery contains less than 10% charge. In this condition, the unit must be
charged immediately. Once the unit is plugged in and the Pink lights have stopped flashing, the unit can be
used. Standard charging times range from 60-90 minutes from 10% charge to a full battery.
To change or replace the battery pack, rotate and remove the magnetic base plate from the SWITCH. Once the
baseplate is removed, position the retainer clips out of the battery’s path and remove the battery pack.
The charging unit includes an indicator light to identify when the unit is charging. If the LED is Red, the unit is
charging. When the LED turns Green, the SWITCH is fully charged.
When the charging unit is not plugged in, the LED will continue to illuminate Green.
Advanced Mode
Advanced Mode offers 25 Power Settings for the advanced user.
This mode is included for those who want even more flexibility in tuning in their ideal setting.
To enter Advanced Mode, start with the power switch in the ‘OFF’ position.
Hold the (Go) button and power on the SWITCH by flipping to either (LEAF)or (OIL) .
Release the (Go) button.
The front LEDs will illuminate in a Rainbow indicating the device is now in Advanced Mode.
Press the (+) or (-) button to display the current Power Setting.
Press or hold the (+) or (-) buttons again to increase or decrease the Power Setting.
1 Purple LED is the lowest Power Setting (profile equivalent to 300 degree range).
1 Orange LED is the highest Power Setting (profile equivalent to 800 degree range).
Wait 5 seconds for the Power Setting to save, or immediately save the Power Setting by pressing the (Go)
button.
After the Power Setting is saved, the front LEDs will illuminate Pink to display the units battery level.
To Next Page
Loading...
