EasyManua.ls Logo

dr trimmer mower Pro - To Reassemble the Mow-Ball Support Assembly

Default Icon
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
DR
®
TRIMMER/MOWER
™
Assembly & Operating Instructions 23
To Reassemble the Mow-Ball
™
Support Assembly
WARNING! Before performing any maintenance procedure, the engine should be stopped
and the spark plug wire disconnected.
Caution: Improper installation may cause damage to the bearings. Please follow these
directions carefully.
1. Reassemble the components in the order shown in
Figure 37.
· The line plates stack on top of one another with
the bumps on the bottom locking into the grooves
on the top of each plate.
· The head of the Mow-Ball
™
bolt should sit in the
groove of the rectangular washer at the bottom of
the Mow-Ball
™
Support. Hold the bolt head in
place with one finger and turn the Mow-Ball
™
Support assembly clockwise until it's finger tight.
Figure 37
dr trimmer mower Pro - To Reassemble the Mow-Ball Support Assembly