DR 16.5 - Page 17

CONTACT US AT www.DRpower.com 17
4. If the oil level is low continue adding a few ounces of oil at a time,
rechecking the Dipstick until the oil reaches the fill mark (Figure 22a and
22b). Be careful not to overfill.
Adding Gas
1. Remove the Gas Fill Cap and fill the Gas Tank with fresh, unleaded gas
(with a minimum of 85 Octane) to approximately 1" to 1-1/2" below the top
of the fill neck to allow for fuel expansion (Figure 21a and 21b). Be careful
not to overfill and reinstall the Gas Fill Cap before starting the engine. See
your Engine Owner’s Manual for more detailed information.
Note: To refill the gas tank, turn the engine OFF and let the engine cool at least five
minutes before removing the gas fill cap.
Check the Tire Pressure
Tools Needed:
 Tire Pressure Gauge
 Air Compressor
1. Remove the Valve Stem Protective Cap and check the tire pressure with a
Tire Pressure Gauge (Figure 23).
2. If the pressure is too low, add air through the Valve Stem with an air hose.
3. Replace the Valve Stem Protective Cap when finished.
Operating
Range
Too Low
(add oil)
Too Full
(drain oil)
Figure 22b: Pro-21.0 Model
Operating
Range
Too Low
(add oil)
Too Full
(drain oil)
Figure 22a: 16.5 Model
Do not over inflate the tires. Inflate to the manufacturers recommended
pressure found on the tires.
Figure 23: Yard-Tow Model Shown
Valve Stem
Protective Cap