What to do if the engine runs but the flywheel doesn't rotate on my DR 18.0 HP?
If the engine of your DR Chipper runs but the flywheel remains stationary, the inner clutch shoes may be worn, the retaining springs could be weak or broken, or the drive belt might be loose. To resolve this, replace any worn or broken clutch components, verify and adjust the belt tension as needed, and ensure the chipper chamber is clear of obstructions.
Why is the chipping action so slow or the flywheel stalling on my DR Chipper?
If the chipping action of your DR Chipper seems slow or the flywheel stalls, ensure the engine is running at full throttle. Also, inspect the belt for looseness or if it's missing, and tighten it as necessary.
What to do if log vibrates excessively and hammers hands when chipping with my DR 18.0 HP?
If logs vibrate excessively and cause a hammering sensation in your hands while using the DR Chipper, it's likely that the knives are dull or the gap between the knife and wear plate is too wide. You should remove and sharpen the knife, maintaining the original 45-degree bevel. Also, adjust the gap according to the instructions.
How to fix chipper knives striking side plate on my DR 18.0 HP?
If the chipper knives on your DR Chipper are moving and striking the side plate, the taper lock bushing may be loose, or the set screws in the flywheel shaft bearings might be loose or missing. If the key in the taper lock bearing is too deep, file it down for proper seating. Then, reset the correct knife gap and tighten the set screws.
Defines the chipper's intended purpose and warns against improper use.
Safety guidelines for children near the chipper during operation or maintenance.
Lists all parts included in the chipper's packaging.
Specifies the tools necessary for assembling the chipper.
Outlines the procedure for unpacking and verifying all components.
Provides detailed instructions for the physical assembly of the chipper.
Details the process of connecting the electrical wire harness to the trailer.
Guide for filling the engine with oil and gasoline before initial operation.
Step-by-step instructions for starting the chipper's engine.
Procedure for safely shutting down the chipper engine.
Instructions on safely removing the chipper knives.
Guidance on sharpening and correctly reinstalling the chipper knives.
Procedures for removing the centrifugal clutch assembly.
Procedures for installing the centrifugal clutch assembly.
General maintenance guidelines for the centrifugal clutch.
Steps for disassembling the centrifugal clutch.
Steps for re-assembling the centrifugal clutch.
To Next Page
General
