DR PILOT - Page 17

CONTACT US AT w w w .DRpow er.com 17
16. Install the top front Tube Frame to the side Tube Frames and secure with
two C-Head Bolts and Knobs (Figure 34).
17. Slide the Top Rear Tube Frame through the Enclosure Loop and secure to
the Side Tube Frames with two C-Head Bolts and Hand Knobs with threads
(Figure 35).
Note: The round Tube portion of the Top Rear Tube Frame is offset from the flat
ends. Install so the offset is facing out towards the back.
18. Adjust the enclosure corner loops so that there is about 1/2" of tube
showing above the tube brackets (Figure 36).
19. Open up the side Loops by pulling at the Velcro closures to separate them
(Figure 37).
20. Fold the Inner Flap over the side Tube Frame and secure the Velcro next to
the Outer Flap (Figure 38). Repeat for the other side.
Top Rear
Tube Frame
Figure 35
Top
Rear
Loop
Hand
Knob
with
Threads
C-Head
Bolt
Tube
Frame
End
Tube Offset
Facing out
Outer
Flap
Figure 38
Inner Flap
Velcro
Side Loop
with Velcro
Figure 37
A
pproximately
1/2"
Figure 36
Top Front
Tube Frame
Figure 34
Hand
Knob
with
Threads
C-Head
Bolts
Bracket