EasyManuals Logo

DR POWERWAGON 5.0 User Manual

DR POWERWAGON 5.0
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
DR POWERWAGON 5.0 Safety & Operating Instructions 28
Figure 29
Adjusting the Shift Lever
If you are unable to shift into reverse or 4th gear, the shift lever and tie rod need to be adjusted.
Tools Needed:
1/2" box wrench or socket
1/2" box or open-end wrench
9/16" box or open-end wrench
1. Move the shift lever into the reverse
position. (Figure 29)
2. Loosen and remove the tie rod nut
and bolt from the transaxle arm with
the 1/2" wrenches (Figure 30). Remove
the tie rod from the transaxle arm.
3. Fully extend the transaxle arm toward
the front of the machine; this will put
the transmission into reverse gear.
(Figure 31)
4. Loosen the lock nut on the shift tie
rod end with the 9/16" open-end
wrench (Figure 31) and turn the tie rod
end, clockwise to shorten the tie rod,
and counterclockwise to lengthen it.
5. Adjust the tie rod length until the shift
indicator points to reverse when the
tie rod end is reinstalled onto the
transaxle arm.
6. When the adjustment is complete, re-
tighten the lock nut against the ball
end.
7. Place the tie rod back on the transaxle
arm, insert the bolt, and re-tighten the
nut.
This should now enable you to use the
full range of gears.
WARNING! Before performing any maintenance procedure, stop the
engine, set the parking brake and disconnect the spark plug wire.
Shift Lever
Figure 3
0
Figure 31
Tie Rod Nut & Bolt
Transaxle Arm
Shift Tie Rod
Lock Nut
Shift Tie
Rod End
Transaxle
Arm Forward

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DR POWERWAGON 5.0 and is the answer not in the manual?

DR POWERWAGON 5.0 Specifications

General IconGeneral
BrandDR
ModelPOWERWAGON 5.0
CategoryUtility Vehicle
LanguageEnglish

Related product manuals