Dräger Babylog 8000 plus - Range of Functions

Instructions for use Babylog 8000 plus SW 5.n 23
Overview
Range of functions
The functions described correspond to the overall
functionality of Babylog 8000. Some functions are
only optional and may not be included in the
individual device configuration. The optional
functions and order numbers for accessories are
listed in the separate list of accessories.
Ventilation functions
For a detailed description of the ventilation modes
and the additional settings, see page 152. For a list
of abbreviations, see page 24.
Ventilation modes
– IPPV/IMV
– SIPPV
– SIMV
– PSV (optional)
– CPAP
Additional settings for ventilation
– VG (optional)
– HFV (optional)
– VIVE
Monitoring functions
The following parameters are monitored:
– Inspiratory O
2 concentration FiO2
– Airway pressure Paw
– Flow, minute volume MV, and tidal volume VT
– Leakage rate Leak
– Respiratory rate for panting breathing Panting
– Apnea alarm time Apnoea time
Babylog 8000 calculates additional lung
parameters using the measured values for
pressure, flow, and volume.
Power supply
The device is supplied with mains power.
Gas supply
The device features country-specific connections
for the gas supply with oxygen and medical
compressed air.
Data transfer (optional)
Babylog 8000 can be equipped with the
"Communication" kit for transferring measured
data and settings to devices such as patient
monitors or computers.
The serial RS232 interface can be used for data
transfer using the MEDIBUS protocol.
An analog interface is available for analog data
output.
Medication nebulization
For medication nebulization a pneumatic
medication nebulizer can be connected.
Non-invasive ventilation
Non-invasive ventilation is possible if BabyFlow
accessories are used. Additional information can
be found in the BabyFlow instructions for use.