Need help?Do you have a question about the Dräger Babylog VN800 and is the answer not in the manual?
General| Device Type | Neonatal Ventilator |
|---|---|
| Ventilation Modes | CPAP, HFOV |
| Respiratory Rate | 1-150 breaths per minute |
| FiO2 | 21 to 100 % |
| Trigger | Flow, Pressure |
| Monitoring | Pressure, Volume, SpO2 |
| Power Supply | 100 to 240 V AC, 50/60 Hz |
| Inspiratory Time Range | 0.1 to 3 s |
| Alarms | Apnea, Disconnection |
| Patient Population | Neonates and infants |
Specifies the device's application for young patients up to 6 years or 20 kg.
Details the device as an intensive care ventilator.
Describes the front view and components of the display unit.
Details the rear view and connectivity ports of the display unit.
Illustrates the front view of the ventilation unit and its parts.
Explains the overall layout and components of the device screen.
Details the elements and functions visible on the main operational screen.
Explains the color coding used for different alarm priorities.
Describes the primary method for interacting with the device controls.
Step-by-step guide to powering on the ventilation system.
Procedures for performing essential system and breathing circuit checks.
Instructions for initiating patient therapy based on height or category.
Describes how to quickly start therapy in emergency situations.
How to select and switch between different ventilation modes.
Guide to adjusting specific ventilation settings for patient care.
Accessing and configuring advanced operational parameters.
Specific operational details for Non-Invasive Ventilation modes.
Operational procedures and monitoring for Oxygen therapy.
Steps to safely stop the ongoing ventilation therapy.
Explains the visual and audible indicators of device alarms.
Procedure for acknowledging and clearing active alarm notifications.
How to configure and adjust the thresholds for device alarms.
Instructions for calibrating the neonatal flow sensor for accurate measurements.
To Next Page