Dräger Babylog 8000 plus - Printing Reports and Trends

Operation
78 Instructions for use Babylog 8000 plus SW 5.n
Printing a report
Measured values, set values, and status values
are printed in the report.
1 Press the Cal. Config. key.
2 Press the Print key.
Printing a single report:
1 Press the Select key repeatedly until Report is
highlighted.
2 Start the print process by pressing the Start
key. The key function changes to Stop.
While the report is being printed, the functions All
and BabyLink are not available. One of the other
functions can be started, however printing will not
begin until the report is finished.
Canceling the print process:
 Press the Stop key.
Automatically printing a report every 30 minutes:
1 Press the Select key repeatedly until 30 min.
report is highlighted.
2 Start the print process by pressing the Start
key. The key function changes to Stop.
Printing a trend
The following measured values from the trend
memory are printed graphically:
– Mean
– MV
– FiO
2
The current position and width of the trend excerpt
from the 24-hour range apply.
1 Open the dialog window by pressing the Cal.
Config. > Print keys.
2 Press the Select key repeatedly until Trend is
highlighted.
3 Start the print process by pressing the Start
key. The key function changes to Stop.
Canceling the print process:
 Press the Stop key.
211202112121122
2112321126