Instructions for use Babylog 8000 plus SW 5.n 99
Configuration
Displaying device information
Open the dialog window by pressing the Cal.
Config. > Config keys.
The following device information is displayed:
– Software version
– Optional enhancements
– Operating hours
– Reference conditions for flow measurement
and the sensor type being used
Setting date and time
This setting is saved after the device is switched
off.
1 Open the dialog window by pressing the Cal.
Config. > Config > Clock keys.
2 Use the and keys to select the
appropriate parameter.
The selected parameter is highlighted.
3 Use the and keys to set the value.
2093821116
To Next Page
Loading...
