Dräger BiliLux User Manual (English)

Other manuals for Dräger BiliLux

Questions and Answers:

R
Richard MasonAug 1, 2025
Why is the irradiance too low on my Dräger Medical Equipment?
- S
  sarah09Aug 1, 2025
  Low irradiance in Dräger Medical Equipment can occur for several reasons: * The light may be too far from the patient; adjust the height of the light. * The irradiance setting may be too low; increase the irradiance setting. * The LEDs may be at the end of their useful life; replace the LED panel. * There might be a radiometer reading error; correct the sensor position and retry the reading.
D
David BurkeAug 6, 2025
What to do if the message ERR is displayed on the radiometer screen of my Dräger Medical Equipment?
- C
  Christopher JacksonAug 6, 2025
  If the message ERR appears on the radiometer screen of your Dräger device, it indicates that the value is out of range. Try positioning the radiometer closer to the patient and attempt the reading again. This message can also appear if the radiometer is too close to the LEDs, so attempt the reading again. If the message persists, it could indicate a faulty radiometer.
B
Brandon HatfieldAug 9, 2025
How to fix Dräger BiliLux if LED lights do not illuminate?
- C
  cartermaryAug 9, 2025
  If the LED lights on your Dräger Medical Equipment do not illuminate, the cause may be a loose power cable connection. Ensure the power cable is securely connected to both the phototherapy light and the mains power. If the issue persists, the LED panel may need replacement. When replacing parts, use only Dräger spare parts.
M
Michael DunnAug 14, 2025
What to do if my Dräger BiliLux Medical Equipment displays a USB error on the phototherapy report screen?
- R
  richardsonruthAug 14, 2025
  The 'USB error' message on the phototherapy report screen of your Dräger device indicates that you tried to export a phototherapy report without a USB flash drive connected. To resolve this, connect a USB flash drive to the phototherapy light and attempt the export again.
J
Jodi GonzalezAug 18, 2025
What to do if Dräger Medical Equipment displays 'No export during running therapy'?
- E
  Emily HendersonAug 18, 2025
  The message 'No export during running therapy' on your Dräger device means that you attempted to export a phototherapy report while the therapy was active. To resolve this, stop the therapy by pressing the Reset button on the phototherapy screen, and then try the export again.
G
gibbsnatalieAug 22, 2025
How to fix a Dräger BiliLux Medical Equipment trolley that does not maintain set height?
- H
  hensonstephanieAug 22, 2025
  If the trolley of your Dräger Medical Equipment does not maintain its set height, it is likely that the tightening knob on the trolley is not tightened sufficiently. Tighten the knob until it is secure.
A
Andrea BuckAug 27, 2025
How to fix a Dräger Medical Equipment spring arm that does not maintain set position?
- M
  melissa99Aug 27, 2025
  If the spring arm of your Dräger Medical Equipment does not maintain its set position, the joints of the spring arm may be loose. Tighten the joints on the spring arm.

Dräger BiliLux Specifications

General

Application	Treatment of neonatal jaundice
Light Source	LED
Safety Standards	IEC 60601-1, IEC 60601-2-50
Type	Phototherapy device
Irradiance	Up to 30 µW/cm²/nm
Power Supply	100-240 V AC, 50/60 Hz
Service Life	20, 000 hours