Dräger Zeus User Manual

Disassembly
Unscrew the CLIC adapter
(optional).
Screw the CLIC adapter
(optional).
Insert cleaning disc into
the adapter. Close adapter
until it snaps.
Remove cleaning disc from
the adapter. Close adapter
until it snaps.
Remove the flow sensors.
Loosen and pull out
the inspiration port.
Screw off the APL valve.
Screw in the APL valve.
Lift off the upper part of
the breathing system.
Assembly
Check the expiration grills.*
Insert and tighten the
expiration port.
Loosen and pull out
the expiration port.
Turn the screws using the key
counterclockwise about 120°.
91 02 537 | 16.08-1 | HQ | PP | Subject to modifications | © 2016 Drägerwerk AG & Co. KGaA
Set the upper part on the lower
part of the breathing system.
Turn the screws using the key
clockwise about 120°.
Check the inspiration grills.
Insert and tighten the
inspiration port.
Insert the flow sensors
Dräger Zeus® Breathing System
Disassembly/Assembly
D-7417-2014
2
5
8
4
7
3
6
* In case the grill is damaged contact DrägerService®

Dräger Zeus Specifications

General

Type	Anesthesia Workstation
Gas Monitoring	O2, CO2, N2O, Anesthetic agents
Power Supply	100-240 VAC, 50/60 Hz
Gas Delivery	Precision electronic gas mixing
Tidal Volume Range	20-1500 ml
FiO2 Range	21 to 100%
Vaporizer Options	Sevoflurane, Isoflurane, Desflurane

Summary

Dr vimDr Zeus Breathing System Disassembly

Unscrew CLIC adapter (optional)

Unscrew the CLIC adapter if it is optional.

Insert and close cleaning disc in adapter

Insert the cleaning disc into the adapter and close until it snaps.

Loosen and pull out expiration port

Loosen and pull out the expiration port.

Loosen and pull out inspiration port

Loosen and pull out the inspiration port.

Remove flow sensors

Remove the flow sensors.

Turn screws counterclockwise

Turn the screws using the key counterclockwise about 120 degrees.

Remove cleaning disc from adapter

Remove the cleaning disc from the adapter and close until it snaps.

Lift off upper part and screw off APL valve

Lift off the upper part of the breathing system and screw off the APL valve.

Dr vimDr Zeus Breathing System Reprocessing Instructions

Manual cleaning and disinfection

Instructions for manual cleaning and disinfection of components.

Machine cleaning and disinfection

Recommendation for machine cleaning and disinfection of components.

Sterilization guidelines

Information on sterilization, noting SpiroLife flow sensors are not suitable for plasma or radiation.

Visual check for components

Guidance on performing a visual check of components after reprocessing.