Vigor160 Series User’s Guide
149
SNMP function. Please type in IPv4 address to specify certain
host.
Trap Community - Set trap community by typing a proper
name. The default setting is public.
Notification Host IP - Set the IPv4 address of the host that
will receive the trap community.
Trap Timeout - The default setting is 10 seconds.
TLS/SSL Encryption Setup Enable SSL 3.0 and / or TLS 1.0/1.1/1.2 – Check the box to
enable the function of SSL 3.0 and/or TLS 1.0/1.1/1.2 if
required.
Due to security consideration, the built-in HTTPS and SSL
VPN server of the router had upgraded to TLS1.x protocol. If
you are using old browser(eg. IE6.0) or old SmartVPN Client,
you may still need to enable SSL 3.0 to make sure you can
connect, however, it's not recommended.
Device Management Check the box to enable the device management function for
Vigor device.
Respond to external device – If it is enabled, Vigor device
will be regarded as slave device. When the external device
(master device) sends request packet to Vigor device, Vigor
device would send back information to respond the request
coming from the external device which is able to manage
Vigor device.
Broadcast DSL status to LAN – Clients in LAN can get current
DSL connection status if such function is enabled.
After finished the above settings, click OK to save the configuration.
F
F
o
o
r
r
I
I
P
P
v
v
6
6
Available settings are explained as follows:
Item Description
Management Access
Control
Allow management from the Internet - Enable the checkbox
to allow system administrators to login from the Internet.
To Next Page
Loading...
Need help?
General
