Vigor2925 Series User’s Guide
13
1
1
.
.
2
2
.
.
6
6
F
F
o
o
r
r
V
V
i
i
g
g
o
o
r
r
2
2
9
9
2
2
5
5
F
F
n
n
LED Status Explanation
Blinking The router is powered on and running normally. ACT (Activity)
Off The router is powered off.
On USB device is connected and ready for use. USB
Blinking The data is transmitting.
On
Wireless access point is ready.
WLAN
Blinking
It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will return
to normal condition after two minutes. (You need to
setup WPS within 2 minutes.)
On Internet connection is ready.
Off Internet connection is not ready.
WAN1~WAN2
Blinking The data is transmitting.
VPN On The VPN tunnel is active.
QoS
On The QoS function is active.
WCF On The Web Content Filter is active. (It is enabled from
Firewall >> General Setup).
On The DMZ function is enabled.
Off The DMZ function is disabled.
DMZ
Blinking The data is transmitting.
LED on Connector
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
WAN1~
WAN2
Right
LED
Off The port is connected with 10/100Mbps
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
LAN1~
LAN4
Right
LED
Off The port is connected with 10/100Mbps
To Next Page
Loading...
Need help?
General
