9
Off The port is disconnected.
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
Right LED
Off The port is connected with 10/100Mbps
Interface Description
Wireless LAN
ON/OFF/WPS
Wireless band will be switched /changed according to the
button pressed and released. For example,
2.4G (On) and 5G (On) – in default.
2.4G (Off) and 5G (On) – pressed and released the button
once.
2.4G (On) and 5G (Off) – pressed and released the button
twice.
2.4G (Off) and 5G (Off) – pressed and released the button
three times.
When WPS function is enabled by web user interface, press
this button for more than 2 seconds to wait for client’s device
making
network connection through WPS.
Factory Reset
Restore the default settings. Usage: Turn on the router (ACT
LED is blinking). Press the hole and keep for more than 5
seconds. When you see the ACT LED begins to blink rapidly
than usual, release the button. Then the router will restart
with the factory default configuration.
USB
Connecter for a USB device (for 3G/4G USB Modem or printer
or thermometer).
WAN2 / P6
Connecter for local network devices or modem for accessing
Internet.
It is a switchable port. It can be used for LAN connection or
WAN connection according to the settings configured in WUI.
LAN P1-P5
Connecters for local network devices.
Phone 1/2 Connecter for analog phone(s).
DSL Connecter for accessing the Internet.
Connecter for installing WLAN antennas.
To Next Page
Loading...
