Need help?Do you have a question about the Draytek VigorSwitch G1240 and is the answer not in the manual?
General| Switching Capacity | 48 Gbps |
|---|---|
| Forwarding Rate | 35.7 Mpps |
| MAC Address Table | 16K entries |
| Dimensions | 440 x 200 x 44 mm |
| Power Supply | 100-240VAC, 50/60Hz |
| PoE | No |
| Jumbo Frame Support | 9K bytes |
| VLAN Support | 802.1Q VLAN tagging |
| QoS | 802.1p QoS support |
| Management | Web-based, CLI, SNMP |
| Operating Temperature | 0°C to 40°C |
| Storage Temperature | -40°C to 70°C |
| Humidity | 10% to 90% (non-condensing) |
| Ports | 24 x 10/100/1000 Mbps Gigabit Ethernet ports |
Provides instructions and requirements for installing the switch hardware.
Details the fundamental principles and operation of network switches.
Explains the concept and benefits of Virtual Local Area Networks (VLANs).
Covers system configuration, including device information and settings.
Details how to view system information and configure IP settings.
Manages individual network ports on the switch.
Allows configuration of port settings such as speed, duplex, and flow control.
Configures the VLAN mode, enabling network segmentation.
Configures IP filters to control access to management functions.
Manages Quality of Service settings for network traffic prioritization.
Sets up QoS modes, 802.1p priority, and DSCP values for traffic management.
Implements port-based network access control using 802.1X authentication.
Provides steps to diagnose and resolve issues where a port shows no link status.
Answers frequently asked questions related to switch operation and configuration.
To Next Page
