Need help?Do you have a question about the Draytek VigorSwitch G1260 and is the answer not in the manual?
General introduction to the VigorSwitch G1260 and its capabilities.
Detailed listing of hardware and management features for the switch.
Step-by-step guide for physical setup, including SFP, chassis, and cabling.
Detailed system settings including IP address, device name, and DHCP.
Settings for individual ports: speed, duplex, and flow control.
Managing VLANs: modes, groups, isolation, and per-port settings.
Implementing port-based network access control using 802.1X authentication.
Identifies common causes for a lack of link status on switch ports.
Addresses computer-to-computer connectivity and uplink failures.
General introduction to the VigorSwitch G1260 and its capabilities.
Detailed listing of hardware and management features for the switch.
Step-by-step guide for physical setup, including SFP, chassis, and cabling.
Detailed system settings including IP address, device name, and DHCP.
Settings for individual ports: speed, duplex, and flow control.
Managing VLANs: modes, groups, isolation, and per-port settings.
Implementing port-based network access control using 802.1X authentication.
Identifies common causes for a lack of link status on switch ports.
Addresses computer-to-computer connectivity and uplink failures.
General| Switching Capacity | 56 Gbps |
|---|---|
| Power over Ethernet | No |
| Layer | Layer 2 |
| Dimensions | 440 x 200 x 44 mm |
| Power Supply | 100-240VAC, 50-60Hz |
| Humidity | 10% to 90% non-condensing |
| MAC Address Table | 16K |
| Jumbo Frame Support | 9K |
| VLAN Support | Yes |
| Quality of Service (QoS) | Yes |
| Management | Web, CLI, SNMP |
| Operating Temperature | 0 to 50°C |
| Storage Temperature | -40 to 70°C |
| Ports | 24 x 10/100/1000Base-T RJ-45 |
| Forwarding Rate | 41.7 Mpps |
To Next Page
