Drayton Digistat 1 User Manual

TO ALTER THE SET
TEMPERATURE
The SET temperature should be adjusted to a
level at which you are comfortable, (try the
preset 20°C to start and adjust if necessary).
Depressing either the + or – button will
activate SET mode and SET room temperature
will be displayed.
The SET temperature can now be adjusted up
or down in steps of 1°C by pressing the + or –
buttons, between a range of 5°C to 30°C.
Pressing a button once will change the
temperature 1°C, holding a button will make
the setting ‘run’. If the selector pin at the rear of
the Digistat has been removed (see installation
instructions) the range is limited from 16°C to
30°C.
The Digistat will rev
ert to displaying actual
room temper
ature 5 seconds after, the
temperature setting is changed and buttons are
released.
BATTERY REPLACEMENT
30 days bef
ore the batter
ies need replacing,
a
battery symbol will flash in the right hand side
of the display.This signifies that 2 x 1.5V type
AA
alkaline batteries will be needed to
replace the existing ones.The battery
compartment is situated at the bottom of the
unit (press to unlatch and slide down).
Ensure
new batteries are installed correctly.When
batteries are replaced the SET temperature
may rev
er
t to 20°C and will therefore need
resetting to the desired level.
After 30 days, only a continuous battery symbol
will be displayed and the unit will remain OFF.
CONFORMS TO THE ESSENTIAL REQUIREMENTS
OF THE FOLLOWING DIRECTIVES:
89/336/EEC – Electromagnetic compatibility
73/23/EEC – Low voltage directive
Digistat 1
Digital room
thermostat
Installation and
operating instructions
SET
Drayton
Invensys Controls Europe
Customer Service Tel: 0845 130 5522
Customer Service Fax: 0845 130 0622
Technical Helpline Tel: 0845 130 7722
Website: www.draytoncontrols.co.uk
Email: customer.care@invensyscontrols.com
An Invensys product
090 677 ISS B

Drayton Digistat 1 Specifications

General

Display	LCD
Temperature Range	5°C to 30°C
Mounting	Wall Mounted
Control Mode	On/Off
Voltage	230V
Switching Current	3A
Accuracy	+/- 0.5°C
Programming	7-day

Summary

Thermostat Operation

Alter Set Temperature

Adjusts the SET temperature using plus or minus buttons within a 5°C to 30°C range.

Battery Replacement

Details the process for replacing AA alkaline batteries before the symbol flashes.

Digistat 1 Installation and Operation

General Description

Overview of the Digistat 1 as an accurate electronic room thermostat for heating systems.

Electrical Connections

Provides a conversion chart for replacing existing room thermostats with the Digistat.

Specification

Lists technical details including temperature range, power supply, and switch rating.

New Installation Location

Guidance on selecting an optimal mounting position, avoiding direct sunlight or draughts.

Installation Fixing

Instructions for mounting the wall-plate, wiring, and securing the Digistat unit.

Maintenance

States that no regular maintenance is required for the product.

Initial Start Up

Steps for initial setup, including battery insertion and understanding display indicators.