The controls are:
DEPTH: Modulation amount
SPD: Modulation speed
WIDTH: When this is at 0, the effect is MONO. As you advance to 100 the left and right channels are split
and a stereo effect is produced. At 100, both left and right channels have a 180 degree inverted modulation.
FEED: Feedback of the effect
MIX: Dry/wet balance. This parameter is global for all 3 algorithms
7.3 FX3: Reflections (Delay, Ping pong, Reverb)
FX3 is dedicated to delay and reverb effects and include:
- Delay (a stereo delay that can have different delay times on each channel)
- Ping pong delay
- Reverb (a huge, lush reverb)
All three share two common controls, that are governed from slider 4 to 5:
DAMP: A lter is added to the feedback loop of the effect. Minus values set a low pass lter and
positive a High Pass one
MIX: Dry/wet balance. This parameter is global for all 3 algorithms
The 3 first controls for the Delay are:
L: Left channel delay time
R: Right channel delay time
FEED: Amount of repeats
For the Ping Pong:
TIME: Delay time
EMPTY: This control does nothing
FEED: Amount of repeats
For the Reverb:
PRE: Pre Delay time. A faint buzzing noise may be heard when changing values while the reverb is active
SIZE: Room size
FEED: Decay time
8. Other settings
The right-most page “SET” allows access to the following settings:
GLIDE: Portamento rate
TRK: Filter key track
VCO: Both VCO1 and 2 levels. This will attenuate the waveform that is produced from
the Wave control
LEGATO button: Legato On or Off (will affect portamento and envelope re-trigger)
12
To Next Page
Loading...
