5
• Make sure the robot is turned off and the charging dock is unplugged before
cleaning or performing maintenance.
• Do not use a wet cloth to wipe or any liquid to rinse the robot and charging dock.
Washable parts must be dried completely before installing and using them.
• Make sure the robot is turned off when being transported and kept in its original
packaging if possible.
• Please use this product in accordance with the instructions in the User Manual.
Users are responsible for any loss or damage that arise from improper use of this
product.
Batteries and Charging
• Do not use any third-party battery, power cord, or charging dock. Use only with
RCS0 supply unit.
• Do not attempt to disassemble, repair, or modify the battery or charging dock on
your own.
• Do not place the charging dock near a heat source.
• Do not use a wet cloth or wet hands to wipe or clean the dock’s charging
contacts.
• Do not improperly dispose of old batteries. Unneeded batteries should be
discarded at an appropriate recycling facility.
• If the robot will not be used for an extended period, fully charge it, then turn it off
and store in a cool, dry place. Recharge the robot at least once every 3 months to
avoid over-discharging the battery.
• This product contains batteries that can only be replaced by qualified technicians
or after-sales service.
Laser Safety Information
• The laser sensor in this product meets the IEC 60825-1: 2014 Standard for Class 1
laser product. Please avoid direct eye contact with it during use.
Product Overview
Accessories
To Next Page
Loading...
Need help?
General
