Why Dreame Vacuum Cleaner misses rooms?
If your Dreame Vacuum Cleaner misses rooms, make sure the doors to those rooms are open. Also, check for thresholds higher than 2 cm at the doorway. If the area in front of the room is wet or slippery, try drying the floor before using the robot.
What to do if Dreame Vacuum Cleaner won't charge?
If your Dreame Vacuum Cleaner isn't charging, check that the base station is properly connected to power by ensuring both ends of the power cord are plugged in. Also, the charging contacts may have poor contact, so clean them. Finally, check for any foreign objects at the connector of the robot and remove them.
How to fix a Dreame RLX41CE that will not turn on?
If your Dreame Vacuum Cleaner robot won't turn on, it's likely due to a low battery. Recharge the robot on its base and try again. Also, ensure the battery temperature is within the recommended operating range of 32°F (0°C) to 104°F (40°C).
What to do if Dreame Vacuum Cleaner robot will not charge?
If your Dreame Vacuum Cleaner robot isn't charging, start by checking that the base station is properly connected to a power source, ensuring both ends of the power cord are securely plugged in. Next, inspect the charging contacts on both the base station and the robot and clean them if necessary. Also, check for any foreign objects at the connector of the robot and remove them.
Why Dreame RLX41CE Vacuum Cleaner won't turn on?
Your Dreame Vacuum Cleaner might not be turning on because the battery is low. Try recharging the robot on the base. If that doesn't work, the battery temperature may be too low or too high. Ensure the appliance is operated between 32°F (0°C) and 104°F (40°C).
What to do if Dreame Vacuum Cleaner fails to connect to Wi-Fi?
If your Dreame Vacuum Cleaner can't connect to Wi-Fi, first ensure the Wi-Fi password is correct. Also, verify that the robot is connected to a 2.4 GHz Wi-Fi network, as it does not support 5 GHz connections. A weak Wi-Fi signal can also be the cause, so place the robot in an area with good coverage. If the issue persists, exit and re-enter the app, then try again.
Why Dreame RLX41CE Vacuum Cleaner robot misses the rooms to be cleaned?
If your Dreame Vacuum Cleaner robot is missing rooms during cleaning, ensure that the doors to those rooms are open. Keep in mind that the robot cannot climb over thresholds or steps higher than 2 cm. Also, if the area in front of the room is wet or slippery, try drying the floor before using the robot.
Why Dreame Vacuum Cleaner robot moves without following the set route?
If your Dreame Vacuum Cleaner robot isn't following the set route, make sure to organize objects like power cords and slippers before use. Wet, slippery surfaces can cause the main wheel to slip, so dry any wet areas beforehand. Also, clean the line laser sensors and AI visual sensor with a soft, dry cloth to ensure they are unobstructed.
Why is Dreame RLX41CE charging so slow?
The charging speed of your Dreame Vacuum Cleaner might be slow because it takes about 4.5 hours to fully charge when the battery is low. If you operate the robot at temperatures outside of the specified range, the charging speed will automatically slow down to extend the battery life. Also, the charging contacts on both the robot and the base may be dirty, so wipe them with a dry cloth.
How to fix Dreame RLX41CE Vacuum Cleaner that moves without following the set route?
If your Dreame Vacuum Cleaner moves without following the set route, make sure objects such as power cords and slippers are picked up. Wet, slippery surfaces may cause the main wheel to slip, so dry any wet areas before using the robot. Clean the line laser sensors and the AI visual sensor on the robot with a clean, soft, and dry cloth to keep them clean.
General| Model Number | RLX41CE |
|---|---|
| Type | Robot Vacuum Cleaner |
| Battery Capacity | 5200 mAh |
| Suction Power | 4000 Pa |
| Navigation | LDS Laser Navigation |
| Mopping Function | Yes |
| Noise Level | 65 dB |
| Connectivity | Wi-Fi |
To Next Page
