The battery runs out
Please charge as soon as
possible.
Error
Please contact our
after-sales service
department for
maintenance.
更换滤芯
参 考 维 护 保 养【 清 洁 滤
芯】部分拆下滤芯更换。
Replace the filter
Refer to the maintenance
guide [Cleaning HEPA
Filter] section to remove
the filter and replace it.
Low battery
Please charge as soon as
possible.
Battery overheating
Please wait and
continue to use after
motor temperature is
normal.
Air duct blocked
Check whether the dust
compartment, extension
rod, and soft roller nozzle
are blocked.
Clean the brush
Refer to the maintenance
guide [Soft Roller Nozzle]
section to clean the fiber
material and hairs
wrapped around the
roller brush.
Reset filter
Press and hold for 5
seconds to enter the filter
reset countdown screen.
When appears on the
screen, it indicates that
the reset is successful.
14 15
EN EN
How to Use
If you need to pay attention to any abnormality during the use of the product, a
prompt will be shown on the screen. You should follow the instructions on the screen
to keep the performance normal.
Care & Maintenance
Tips:
1.
Always use genuine parts to keep your warranty from becoming void.
2.
If the lter or nozzle becomes clogged, the vacuum will stop working shortly
after being turned on. To restore normal functions, clean the lter and/or nozzle.
3.
If the vacuum will not be used for an extended period, fully charge it, unplug
its power adapter, and store it in a cool, low-humidity environment away from
direct sunlight. To avoid over-discharging the battery, recharge the vacuum at
least once every 3 months.
Cleaning the Vacuum
Wipe the vacuum with a soft dry cloth.
Cleaning the Dust Cup
Before cleaning the dust cup, disconnect the adapter and keep the vacuum's power
switch in the o position. The vacuum's cleaning ability will be reduced if the dust
cup is lled to the "MAX" mark. To retain performance, remember to empty the cup.
1. Empty the dust cup: Press the release button on the bottom of the cup, then empty
its contents.
2. Clean the dust cup: Use a dry cloth or paper towel to wipe the dust from the inner
wall of the dust cup.
To Next Page
Loading...
Need help?
General
