14
Flip the vacuum-mop over, then gently pull out the side brush as shown in
the diagram below to clean it.
Side BrushMain Brush
1. Flip the vacuum-mop over and pinch the clips to remove the main brush
guard. Lift the main brush out of the vacuum-mop, then clean the brush
bearings.
2. Use the included brush cleaning tool to remove any hairs tangled on the
brush.
Note: If there is a large amount of hair or hair is tightly entangled, remove it carefully to
avoid damage to the main brush.
Omnidirectional Wheel
Flip the vacuum-mop over and pull out the omnidirectional wheel. Remove
hair, dirt, and other debris from the wheel and axle.
Note: Use tools such as a small screwdriver, etc. to separate the axle and the tire.
Routine Maintenance
To Next Page
Loading...
