13
Routine Maintenance
Mopping Module
1. Press the side clips of the mopping module inward and pull to remove
the module.Pull the mop pad o of the mopping module to remove it.
2. Empty the remaining water in the water tank and keep it dry naturally.
3. Clean and dry the mop pad.
Note:
• Remove the pad from the mopping module before cleaning it, and make sure dirty
water does not ow back into the water outlet to avoid clogging.
• Do not press too hard on the mop pad, as this can hinder its performance.
• Pad should be cleaned before each use. It is recommended to change the mop pad
every 3 to 6 months.
12
6
111
57
210
48
9
24 hrs
4. If slow water ow occurs, or the volume is not well-distributed, please
clean the air hole in the cover of the water tank.
To Next Page
Loading...
