DreameTech T10 - FAQ

21
FAQ
If the vacuum is not working properly, please refer to the table below.
Errors Possible Causes Solutions
Vacuum does
not work.
Vacuum is out of battery or
low on power.
Fully charge the vacuum, then
resume use.
Overheat protection mode
triggered by a blockage.
Clean the suction openings or air
duct. Wait until the vacuum cools
down, then reactivate it.
Suction opening or air duct is
blocked.
Clear any blockages from suction
opening or air duct.
Weak suction
force.
Dust cup is full and/or filter
assembly is clogged.
Empty the dust cup and clean the
filter assembly.
Attachment is blocked.
Clear any blockages in the
attachment.
Motor makes a
strange noise.
Main suction opening or
extension rod is blocked.
Clear any blockage in the main
suction opening or extension rod.
The first
indicator is red
after turning on
the vacuum.
Battery pack is damaged.
Please contact after-sales service
to arrange maintenance.
The first
indicator blinks
red when
charging the
vacuum.
The charger is incompatible.
Only use the original charger to
charge the vacuum.