x2
11
i)
ii)
a x2
c x2
a x2
c x2
c
d
x1
a
x6
x6
T
M
U
Y
Z
12
c
m
b
c
m
b
P
Q
b
x5
c
x5
d
x1
m
x5
The bolts should be in the centre of the
long holes and one may need to slide
the inner bar and the bracket, up or
down so the bottom of the O.S.B stem
just touches the surface - better to do
this AFTER the mattress is fitted.
90%
ii)
To underneath of mattress base board, fit the parking
bracket (Q). This is used to safely keep the support
bar out of the way when not in use. Use one bolt set
(m, b & c) - please make sure the bracket is fitted
the correct way round as shown. Screw into the
threaded insert on the underside of the frame.
i)
iii)
100%
To underneath of mattress base board,
fit the O.S.B. support bar (O) as shown.
Using two bolt sets (m, b & c), screw
the bolts into into the threaded inserts
on the underside of the board.
Please do tighten 100% yet.
Fit the fixed retaining bracket
(P) to the side rail using two
bolt sets (m, b, & c). Screw the
bolts into the threaded inserts
on the side rail. Make certain
the bracket is level and at the
correct height.
Please do not tighten 100% yet.
Unpack the contents of the Ottoman Support Bar (O.S.B.) from it's
carton - this is packed inside Pack 2.
iv)
WARNING! HAZARD
DO NOT R EACH INTO THE SPACEB
ELOW!
O
100%
c x2
m x2
b x2
Bethany & Chloe Ottoman Bed - Assembly guide - Page 19
Fit the accessories.
To Next Page
Loading...
