7. Secure the WORKPIECE to the base before drilling.
This will keep the workpiece from climbing the drill or
spinning. The benefit is safety and you will do better
work also. HOLD DOWNS (Not Included) are very
good for holding a workpiece. Or use a small utility
vise for holding when drilling.
8 Loosen the LOCK KNOB one-half turn and move the
head housing until the drill bit tip is near the work-
piece. (A maximum of 1/4 between drill tip and work-
piece is recommended.) Retighten lock knob.
HELPFUL HINTS
9. When drilling ROUND PIECES, use a "V" BLOCK
or vise .To drill a hole in the center of a round piece, a
center punch mark is necessary, small flat is better if
tolerable.
1O.Avoid force feeding to such an extent that the motor is
noticeably reduced. Also feed carefully when
approaching point of breakthrough. This will avoid
making ragged breakthrough edges.
HEIGHT
ADJUSTMENT
11. For accurate drilling lower the head housing to a loca-
tion where the end of the drill bit is within 1/4" of the
workpiece before advancing the handle for feeding the
drill. Using minimum stroke and center punching at
the location to be drilled will ensure accurate drilling.
ROUND PIECES
If/~B~K
DREMEL:
Form No. 5294196
4 ~ If'
PRINTED IN U.S.A.
p.o. Box 1468
Racine. Wisconsin 53401
To Next Page
Loading...
