Need help?Do you have a question about the Dremel 230 and is the answer not in the manual?
General| Type | Rotary tool |
|---|---|
| Voltage | 230 V |
| Variable Speed | Yes |
| Collet size | 3.2 mm |
| Power Source | Corded |
Instructions for assembling the Dremel Drill Stand.
Guide on attaching various Dremel tool models to the drill stand.
How to adjust the depth setting on the drill stand for precise work.
Instructions for using the depth stop mechanism on the drill stand.
Illustrated guide for attaching the flex-shaft attachment.
Information on servicing and part numbers for the flex-shaft attachment.
Instructions for mounting various Dremel tool models onto the router attachment.
Guide for installing the rip fence component onto the router attachment.
Instructions on how to adjust the rip fence for accurate cuts.
Steps for setting the correct routing depth for different applications.
How to perform circle routing operations using the attachment.
Technique for routing the exterior surfaces of workpieces.
Technique for routing the interior surfaces of workpieces.
Instructions for assembling the router table unit.
Guide on attaching various Dremel tool models to the router table.
How to adjust the depth of the router bit on the table.
Instructions on how to properly use the provided wrench.
Techniques for routing both external and internal surfaces.
Guide on how to use the 'A' support for stability and precision.
Best practices for routing direction when using pilot bits.
Essential safety warning about keeping hands clear of moving parts.
Instructions for increasing the router table's work surface area.
Guidance on choosing the appropriate bit size for sharpening.
Step-by-step instructions for mounting the sharpening bit.
Detailed procedure for sharpening a chainsaw chain.
To Next Page
