Dremel 400 Series XPR Instructional Safety Manual

11
SPEED SETTINGS
Catalog
Number
100, 121, 131
114, 124,
134, 144
190
118, 191, 192,
193, 194
116, 117,
125, 196
115
198
199
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
810 5 5 6 - - -
86 4 5 6 - - -
810 4 7 8 - - -
810 4 5 8 - - -
86 4 5 6 - - -
810 4 5 6 - - -
88 4 5 6 - - -
88 4 5 6 - - -
High Speed Cutters
Catalog
Number
105, 108
106, 109
107, 110
111
112
113
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
810 6 4 6 - - -
8 10 54 6---
810 5 4 6 - - -
8* 10* 6* 4 6 - - -
8* 10* 5* 4 6 - - -
8* 10* 5* 4 6 - - -
Engraving Cutters
Catalog
Number
7103, 7105,
7117, 7120,
7122, 7123,
7134, 7144
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
10 8 - - - 10 10 10
Diamond Wheel Points
Catalog
Number
9931, 9932,
9933, 9934,
9935, 9936
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
88 4 - 6 - - -
Structured Tooth Tungsten Carbide Cutters
Catalog
Number
9901, 9902,
9903, 9904,
9905, 9906,
9909, 9910,
9911, 9912
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
8
8
4 8-10 6 8 8-10 8-10
Tungsten Carbide Cutters
Use only Dremel™ tested, high performance accessories.
* Speed for light cuts; Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.

Dremel 400 Series XPR Specifications

General

Speed Range	5, 000 - 35, 000 RPM
Voltage	120V
Power Source	Corded Electric
Collet Size	1/8 inch
No Load Speed	5, 000 - 35, 000 RPM
Warranty	2 years
Cord Length	6 ft
Length	9 inches