GETTING STARTED
permits the tool to be grasped much like a pen or
gentle touch gives the best control and reduces the
HOLDING THE TOOL
Always hold the tool away from your face.
Accessories can be damaged during handling and
When holding tool, do not cover the ventilation
openings with your hand. Blocking the ventilation
openings could cause the motor to overheat.
grip method is used for heavier operations such as
ON/OFF
ELECTRONIC MONITORING
battery performance by cutting the voltage to the tool
by cutting back the voltage to the motor in these
LEARN THE SPEEDS
•
•
VARIABLE SPEED DIAL
To select the right speed for each job, use a
practice piece of material.
OPERATING SPEEDS
Aa
Most jobs can be accomplished using the tool at the
is usually best for polishing operations employing the felt
•
•
rpm to prevent damage to the brush and your
•
•
•
•
to prevent the cut material from adhering to the
NOTE: Increasing pressure on the tool is not the
answer when it is not performing properly. Try a
dierent accessory or speed setting to achieve the
desired result.
MANAGING SPEED SETTINGS IN THE APP
You can preselect a speed between 5,000 – 30,000
RPM on the Dremel App.
• Once you have chosen your desired speed on
the app, the corresponding speed will blink for 10
seconds on the speed indicator J on the tool 7.
• seconds
otherwise the tool will turn on at its default speed
setting of 15,000 RPM.
LEARN THE LED BEHAVIOR
•
minutes as long as your tool is still connected to
•
•
the battery pack.
RED WARNING LED
H
•
•
to return to normal operating temperature before
•
24
To Next Page
Loading...
