28
Speed Settings
Note: Each number settings listed in the speed charts = x 1,000 RPM
* Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Note that the recommended speed may not be suitable for your rotary tool model.
High Speed Cutters
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
100, 121, 131 25-35 25-35 12-17 12-17 18-24 - - -
114, 124, 134, 144 25-35 12-17 9-11 12-17 12-17 - - -
118, 190, 191, 192,
193, 194
25-35 25-35 9-11 12-17 25-35 - - -
116, 117, 125, 196 25-35 12-17 9-11 12-17 12-17 - - -
115 25-35 25-35 9-11 12-17 12-17 - - -
198, 199 25-35 18-24 9-11 12-17 12-17 - - -
Engraving Cutters
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
105, 108 25-35 25-35 18-24 9-11 12-17 - - -
106, 107, 109, 110 25-35 25-35 12-17 9-11 12-17 - - -
111 25-35* 25-35* 18-24* 9-11 12-17 - - -
112, 113 25-35* 25-35* 12-17* 9-11 12-17 - - -
Diamond Wheel Points
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
7103, 7105, 7117,
7120, 7122, 7123,
7134, 7144
25-35 18-24 - - - 25-35 25-35 25-35
Structured Tooth Tungsten Carbide Cutters
Catalog
Number
Soft
Wood
Hard
Wood
Laminates
/Plastics
Steel
Aluminum,
Brass, etc.
Shell/
Stone
Ceramic Glass
9931, 9932, 9933,
9934, 9935, 9936
25-35 18-24 9-11 - 12-17 - - -
To Next Page
Loading...
