Page 9;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 61311
EF;6GHIJ6KFGLIMNFLMG6MFMO6 E6GPJ
R*8*(,7%I/*(,$"83%L8#$('4$"&8#
1. Make sure that the Switch is in the
off-position, then plug in the tool.
2. Turn on the Switch.
3. Run the Sander for a few seconds
before contacting the workpiece.
4. Contact the workpiece with minimal pressure.
Use sandpaper with a lower grit number
to remove material faster.
M&$*- All orbital sanders leave sanding marks
on the workpiece. To minimize sanding marks,
always try to sand with the grain of the wood.
5. Occasionally check the sandpaper for tears,
wear, or fraying. Replace if necessary.
QFKMLMRk The tool will restart automatically if stalled.
6. To prevent accidents, turn off the tool and
unplug it after use. Clean, then store the
tool indoors out of children’s reach.
To Next Page
Loading...
