Page 8 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 61311
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
I/*(,$"83%L8#$('4$"&8#
%K*,9%$.*%6MGLK6%LNJIKGFMG%EF;6GH%LM;IKNFGLIM%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%
5,8',7%"847'9"83%,77%$*Z$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
G&&7%E*$'/
GI%JK6!6MG%E6KLIPE%LMiPKH%;KIN%FOOLU6MGFT%IJ6KFGLIM-%
N,X*%#'(*%$.,$%$.*%E)"$4.%"#%"8%$.*%&22?/&#"$"&8%,89%'8/7'3%$.*%$&&7%2(&5%"$#%
*7*4$("4,7%&'$7*$%+*2&(*%/*(2&(5"83%,8V%/(&4*9'(*%"8%$."#%#*4$"&81
F$$,4."83%E,89/,/*(%$&%$.*%S,4X"83%J,9
1. Press the tab on the Clamps inward on both
sides of the unit and swing the clamps on both
sides up, out, and down. See >%j%a, right.
2. Cut the sandpaper to fit the 4″ W x 4-1/2″ L Pad,
with a little extra to overlap and fit under the
Clamps. U&%8&$%'#*%$&(8%&(%2(,V*9%#,89/,/*(1
3. After wrapping the overlapped edges
of sandpaper under the Clamps, snap
the Clamps back into place.
E,89/,/*(%3&*#%
'89*(%.*(*1
Q&(X/"*4*%,89%Q&(X%F(*,%E*$%P/
1. Workpiece selection:
a. Workpiece must be free of foreign objects.
b. Wear a NIOSH-approved respirator and
have appropriate ventilation whenever
sanding pressure treated lumber.
2. Designate a work area that is clean and well lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
3. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
4. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
5. There must not be objects, such as utility lines,
nearby that will present a hazard while working.
To Next Page
Loading...
