Installing Your Water 1000 Pro Series
Installing Your Water 1000 Pro Series 2-36
acc.
P
If your low water pressure requires a Parallel Conguration, you will be
connecting your 1000 Pro Series and refrigerator (or whatever other appliance
was originally connected to your water source) rst to
E
1/4 in. Brass Compression Tee, and then connecting this to the water source. You can
locate where they connect to the Brass Compression Tee wherever is most convenient.
Just be sure to allow enough length when cutting sections of
A
1/4 in. White PP Tubing. Also, if your appliance has a hose (rather than port) that isn’t
long enough to reach, .
Diagram 2.6.2 - Example of Brass Compression Tee Used As Hub
Adapting
3. If your accessory appliance(s) has a Male Compression Port or Hose, you ‘ll
need to convert it to Quick Connect. Screw
B
1/4 in. Compression To Quick Connect Adapter clockwise tightly onto the port. From
this point on, you will follow the Quick Connect Port instructions for this appliance.
To Next Page
Loading...
