Titan LTE Owners Handbook (Issued 07/17)
FREEWHEEL MODE
Your power powerchair is equipped with
two freewheel levers. These levers allow
you to disengage the drive motors and
maneuver the chair manually.
Press the yellow levers (shown in
photograph) up to engage freewheel
mode.
Press the levers down to engage drive
mode.
Caution
DO NOT use your powerchair while the drive motors are disengaged unless someone is
there to push you. The chair could roll on its own causing injury!
To engage or disengage the freewheel feature:
1.
Pull the freewheel levers upward to disengage the drive motors.
2.
Push the freewheel levers downward, to engage the drive motors.
Caution
It is important to remember that when your power powerchair is in freewheel mode, the
braking system is disengaged.
CIRCUIT BREAKER
If the powerchair is overloaded (from use on a
gradient for example), then circuit breaker will
activate to protect the powerchair from damage.
If the circuit breaker activates, then the
powerchair will be unresponsive.
Press the circuit breaker to reset, as shown in
the photograph.
To Next Page
Loading...