Drive 15230 - Warranty

10
MAINTENANCE AND SAFETY CHECKS
Drive recommends the following maintenance and cleaning procedures be conducted
between users and at least once every three (3) years. This form is provided as a guide to
help with documentation.
ELECTRONICS
• Check all controls to make sure all functions work properly.
• Foot control
• Head control
• Hi/Lo (if applicable)
• Check all cables for damaged or frayed wires.
• Power cord
• Pendant hand control cord
• Check to make sure all plugs are fully inserted or attached.
• Check to make sure all wires are routed and attached properly so not to
interfere with any moving parts.
BED FRAME AND SLEEPING SURFACE
• Visually check all welds
• Head section
• Foot Section
• Main Frame
• Check joints between sleeping surface sections for loose fasteners.
CLEANING
• The metal parts of the bed are covered with a powder coating. Clean all coated
parts with mild detergent and warm water. Periodically raise head and foot
sections of the bed and remove dust from frame. Also, periodically remove
mattress and clean mattress deck.
LUBRICATION AND MECHANICAL
• Lubricate all caster roller and swivel bearings with light machine oil.
• Check all bolts and tighten as needed.
WARRANTY
Lifetime on frame
Two Year warranty on all components.
During the warranty period, defective items will be repaired or replaced at
Drive’s option at no charge.
WARRANTY
WEIGHT LIMIT: 450 LBS.