27 28
mmHg
M
D
M
D
No
5. Deleting/Storing Test Results
User may delete their current test result due to unfavorable
testing conditions or for any other reason. To delete the last
test result, press the “SET” button after result is displayed.
If result is not deleted, it will automatically store by date within
the previously configured Memory Group.
Note: Be sure the appropriate Memory Group selection is made
prior to testing.
If the number of tests surpasses the allotted 60 memories per
group, the most recent tests will appear first, thus eliminating
older readings.
Memory Check & Last 3 Tests Average
With power off, press the “ M ” button to activate
screen display. After the unit performs a self diagnosis, the
screen will display the average test results from the last 3
readings of the last group used. The “
AVG
” symbol will appear
along with the corresponding WHO Blood Pressure Indicator.
To check the average results from other groups, select the
desired group first prior to activating the “ M ” button
in the off position (See “Select Memory Group” on page 13).
Power Off
The “ START/STOP ” button can be pressed to turn off the unit
in any mode.
The unit can turn off the power itself about 3 minutes if there is no
operation in any mode.
Safety Precaution: If pressure in cuff becomes too extreme
while testing, press the “ START/STOP ” button to turn
power off.
The cuff pressure will rapidly dissipate once the unit is off.
Press the “M” button again, you may check past test results. Upon
activating test results, you can press the “M” button to scroll
through all test results stored in memory. The LCD will display the
last memory as NO: 01 reading.
Note: Past test results will only be displayed from the most
recently used memory group. To check past test results
in other memory groups, you must first select the desired
group and then turn monitor off. (See Select Memory Group
on Page 13. )
Memory Deletion
Memory for a selected group may be deleted while in Memory
Check mode. Press and hold the “ SET “ button for
approximately 3 seconds to delete all memory records from the
selected group. The monitor will beep indicating successful
deletion and then transfer into testing mode. To delete momories
from other groups, please refer to “ Select Memory Group ” on
page 10. Then press the “ START/STOP ” button to turn the unit
Note: Memory cannot be recovered once it has been deleted.
Low Battery Indicator
4 short warning beeps sound when battery life is depleting and unable
to inflate cuff for testing. The " " appears simultaneously for
approximately 5 seconds prior to shutting down. Replace batteries at
this time. No memory loss will occur throughout this process.
Unit Operation
Unit Operation Unit Operation
Unit Operation Unit Operation
Unit Operation
mmHg
M
D
AV G
1
1
1
1
AVG
To Next Page
Loading...
