Enigma Lightweight Aluminium Wheelchair (LAWC_IFU 12/14) Page 3 of 12
For optimum comfort it is important to attain the correct leg position. The
footrests have been designed so that they can be extended into one of 5
fixed positions. Unscrew the black knob on the back of the silver tubing.
Adjust the legrest as required then reattach the black knob to secure.
To install the leg rests, place the leg rest
brackets on the pins at the side of the
wheelchair frame (as shown by “1”) then swing
in the leg rest (“2”) until it locks in position.
Leg rests will swing in or out to reduce the
length of the wheelchair. Push chrome lever
whilst rotating the leg rest. To remove, simply
pull up on the leg rest when swung out.
Push the black paddle towards the back post
with your thumb (1) whilst pulling the handle
down (2), as shown. Repeat this operation for
the other handle. To put the backrest back
into position, lift both handles together and
the folding mechanism will lock back
automatically.
Do not push down on the handles to raise
the front of the wheelchair, as this could
result in damage to the wheelchair. Use the
stepper tube as described later in the
handbook.
To Next Page
Loading...
