Drive Royale - Charger Appearance and Specification; Operating Instructions and LED Description; Troubleshooting Charging Issues; Battery Maintenance and Care

Royale By Drive Owner’s Handbook Page 9
BATTERY CHARGING
1. APPEARANCE
2. SPECIFICATION
Power Cord
Output Plug to Battery
Indicator:
Green Flash: Power On
Orange Flash: Pre Charge
Orange: Charging
Green & Orange Flash: Charged 80%
Green: Full Charged
Red Flash：Defective
Item
BATTERY CHARGER
(SWITCHING MODE)
Model
4C24080A
Output Current(DC)
8A±5%
Charging Voltage(DC)
28.8V
Floating Voltage(DC)
27.6V
Input Current (AC)
3.8A max.
Input Voltage(AC)
100 ~ 240 V 50/60Hz
Efficiency
AC-DC 85% min
Operating Temperature
0°C ~ 40°C
Switching Method
SWITCHING MODE
Charging Method
Constant current two stage
constant voltage
Battery Application
24V Lead Acid Rechargeable
Battery (26Ahr ~ 75Ahr)
Output Detection
1.Short Circuit Protection
2.Reverse Power Protection
3.Overheat Protection
4.Charging Plug Protection
Operating Humidity
20％ ~ 85 %
Measure
L 185mm×W 130mm×H 195mm
Weight
1.7K g
Color
Blue
3. OPERATING INSTRUCTION
Plug in the power cord. The LED will flash green
when mains power is on.
Connect the battery charger to the battery.
Start charging; please refer to 4. LED
Description.
The scooter should be charged for 12 – 14 hours
for a full recharge. Failure to do this could result
in a reduced range.
4. LED DESCRIPTION
(1) Green Flash: Power on
(2) Orange: Charging
(3) Orange Flash: Pre charge
(4) Green & Orange Flash: Charged 80%。
(5) Green: Full charged (Floating charge)
(6) Red Flash: Defect
5. TROUBLE SHOOTING
If the LED is not lit：
Check the mains power. If the socket is
working then the charger has an error.
If green LED keeps flashing and cannot turn
orange or green：
Check that the battery connector is
connected properly.
Check if there is any short circuit on the
output connection.


