-18-
SPORT MODE
NORMAL MODE
ATTI MODE
GPS MODE GPS MODE
2. GPS MODE (REFER TO PG 4): Programmed for OUTDOOR flight in open areas that are free from signal interference. After the drone and
remote control are synced with each other (takes about 40 secs) you’ll notice the remote LCD display changes from “CONNECTING” to
“POSITIONING”. At this time, the drone begin searching for a strong satellite signal. The drone will enter GPS MODE after a couple minutes once
it’s gained at least 8 sattelites, which will be shown on your remote’s LCD display. You must be outside with a clear view of the sky. While waiting
for the drone to gain 8 or more satellites, calibrate the drone by following instructions for “geomagnetic & gyroscope calibration. There should be no
obstructions such as high-rise buildings or cars, high-voltage power lines, etc., otherwise the drone may not be able to complete GPS satellite
search and positioning. When 8-10 satellites are gained, GPS positioning is complete, which is indicated by a ”BEEP” sound from the remote
control, and the LCD display changes from “POSITIONING” to “GPS MODE”. You can unlock the drone motors and take flight in GPS MODE.
figure 1 figure 2
Unlocking Drone Motors
Flight Mode Types: ATTI MODE vs GPS MODE
To unlock your LIMITLESS 4 drone, pull BOTH joysticks simultaneously DOWN & IN (Figure 1), or DOWN & OUT (Figure 2).
This will unlock the drone by starting the motors (propellers will spin but drone won’t take off until you either press the take-off button
on the remote control OR you push the LEFT joystick upwards
NORMAL MODE is the default mode upon turning drone on. Obstacle Avoidance function is ENABLED in this Low Speed mode. If you switch
to SPORT MODE, the drone will fly FAST with sharp meneuvering, but obstacle avoidance functions are disabled in this mode as a result.
Therefore, to ensure accidents don’t occure, it’s impertive you pay attention to the drone’s surrounding environment, as well as its flight altitude
and distance.
Speed Modes: LOW (Normal Model) and HIGH (Sport Mode)
Short press this key to switch speed to NORMAL MODE Short press same key to switch speed to SPORT MODE
NORMAL MODE: Low speed with stable flight. Obstacle
Avoidance function ENABLED in this mode.
SPORT MODE: High-speed mode. Obstacle Avoidance
function DISABLED in this mode.
1.
ATTI MODE (aka “INDOOR MODE” or “Optical Flow Mode”): Is applicable to large indoor
open places, such as a spacious gym. Refer to PG 4.
The default settings are programmed for the automated protection program to prevent the
drone from taking flight until the system connects to enough satellites to enter GPS MODE;
however, if the user wants to fly indoors (in ATTI Mode) the user can simply override this
automated failsafe protection, and by doing so, won’t have to wait for a strong GPS satellite
connection in order to take flight. But before you do this, make sure the drone and remote
control are synced with each other, and that you’ve calibrated the drone successfully by
following instructions for “geomagnetic & gyroscope calibration”.
IMPORTANT NOTE on ATTI MODE: When in ATTI MODE, the drone will NOT have GPS safety features, including Auto Return Home functions,
such as “low power return”, “1-key return”, etc. Please pay attention to the flight distance and altitude when flying in ATTI MODE. This is the
reason why we suggest the drone should only be flown indoors when in ATTI MODE since the drone does NOT have GPS capabilities when in
ATTI MODE. In order for GPS “Return To Home” (RTH) Functions to be activated, you must fly in GPS MODE (also known as Mode 2).
To fly in ATTI MODE, simply override the protection failsafe by pressing / holding the headless
mode key for 5 seconds on the remote control (see photo below for location of this key). The remote control will emit a "BEEP" sound, and the
remote’s LCD display screen will change from “POSITIONING“ to “ATTI MODE”, which means the failsafe is OFF and the drone is now able to
take flight indoors.
KEEP IN MIND – If you take flight in ATTI Mode, you won’t be able to switch back to to GPS mode during that flight session. If you need to use
GPS mode, then land the drone and restart the drone & remote control outside with a clear view of the sky. Then wait for it to connect to at least 8
satellites, at which time the remote control will display GPS MODE to indicate you now have a strong GPS connection and are ready to take-off.
IMPORTANT NOTE on GPS MODE: If the drone does not gain enough satellites to enter GPS MODE, then the drone will NOT take-off. This is
a built in failsafe to prevent users from taking flight outside of GPS mode. If the user takes off before entering GPS mode by overriding this
protective failsafe, then keep in mind the drone won’t know where to return home to if an issue arrises, such as loss of signal, low battery, etc.
Drone-Clone Xperts
Drone-Clone Xperts
Drone-Clone Xperts
Drone-Clone Xperts
Drone-Clone Xperts
To Next Page
Loading...
Need help?
General
