13
9. MAINTENANCE PROCEDURE
SMART2 has been designed and manufactured to require the minimum maintenance. Anyway, it is
recommended :
To keep the unit clean and periodically to check pipe joints to readily detect possible leaks.
PERIODICAL MAINTENANCE
Inspection
Number of
work cycles
Maintenance Procedure
Lubrication 1.000 -
Cleanliness of refill filter 4.000 Replace the refill filter, if necessary
Cleanliness of reservoir 6.000 Clean the bottom of the reservoir in case of impurities
10. DISPOSAL
During maintenance or disposal of the machine care should be taken to properly dispose of environmentally
sensitive items. Refer to local regulations in force in your area.
When disposing of this unit, it is important to ensure that the identification label and all the other relative
documents are also destroyed.
11. ORDERING INFORMATION
11.1
MANUAL SMART2
11.2 AUTOMATIC SMART2
PART N° DESCRIPTION
3600240 SMART2 ELECTRO-PUMP 110V/50 Hz
3600241 SMART2 ELECTRO-PUMP 110V/60 Hz
3600242 SMART2 ELECTRO-PUMP 220V/50 Hz
PART N° DESCRIPTION
3600210 SMART2 ELECTRO-PUMP 110V/50 Hz
3600211 SMART2 ELECTRO-PUMP 110V/60 Hz
3600212 SMART2 ELECTRO-PUMP 220V/50 Hz
The machine does not require any special tool for check or maintenance tasks. However, it
is recommended the use only of appropriate and in good conditions tooling, protective
devices (gloves) and clothing (626/94 and DPR 547/55) to avoid injury to persons o
damage to machine parts.
WARNING: It is recommended the use of impurity-free lubricant
WARNING: Prior to any maintenance, be sure that the power and the hydraulic supplies
are off and there is no residual pressure in the main/branch pipe.
To Next Page
Loading...
Need help?
General
