2928
Tire pressure and maintenance (continued)
Tire inflation / deflation:
Do NOT use pressure air supplies found at gasoline stations when inflating/deflating the tires,
as they are not designed for this product.
To inflate each tire (if the pressure level is too low):
• Remove the tire valve cap.
• Use a standard bicycle tire air pump (not included) to connect to the tire valve.
• Follow tire pump instructions to properly inflate the tire to the designated PSI.
Be sure not to overinflate.
• Replace the tire valve cap.
To deflate each tire (if the pressure level is too high):
• Remove the tire valve cap.
• Use a standard bicycle tire air pump (not included) to connect to the tire valve.
• Follow tire pump instructions to properly deflate the tire to the designated PSI.
Be sure not to deflate too much.
• Replace the tire valve cap.
Tire pressure and maintenance (continued)
Additional tire maintenance:
Before using your product, it is strongly recommended to apply a tire sealant/additive to
both tires to help prevent potential punctures.
Tire sealant/additive is NOT included with this product.
To apply the tire sealant/additive properly and safely, refer to the instructions provided
on the tire sealant/additive.
Droyd is not responsible for any injuries, damage, or legal disputes that may result from defective
tire sealant/additive products, improper application of them, or any subsequent failure affecting the
product’s performance.
To Next Page
Loading...
