1)
Step three: Adjusting the headlight
Step two: Tightening the brake lever
1716
• Locate the brake lever and 5 mm allen wrench.
• The brake lever is already pre-installed on the left side of the handlebar,
with the lever facing outward.
• Ensure the brake lever screw hole is aligned.
• Using the 5 mm allen wrench, fully tighten the screw from the bottom.
•
Ensure that the brake lever is fully and tightly installed by pulling on it.
There should be no looseness.
•
Locate the 10 mm wrench and 13 mm wrench.
•
The headlight is already pre-installed onto the frame, folded in the
downward position.
•
Fold the headlight up, so the headlight is facing outward.
•
Locate the pre-installed screw and nut at the base of the headlight.
•
Simultaneously use the 13 mm wrench to brace the screw, and use the 10 mm
wrench to tighten the nut. Continuously rotate the wrench until the nut is fully tightened.
•
Ensure that the headlight is fully and tightly installed by pulling on it.
There should be no looseness.
•
The headlight switch is located beneath the battery level indicator on the
right handlebar. (Note that the headlight switch will NOT turn on the headlight
while the product is powered off.)
Power on
Ignition key:
The ignition key should be in the parent or adult supervisor’s possession at all times,
unless the product is in use (under parental or adult supervision if the rider is below the
age of an adult as defined by law).
The ignition key is used to turn on the motor by fully inserting it inside the ignition and
turning the key to the right. (The ignition is located on top of the battery pack.)
The ignition key must stay in the ignition while the product is in use.
The ignition key must be removed from the ignition while the product is not in use.
To Next Page
Loading...
