1514
Assembly
Assembly must be conducted by an adult.
DO NOT ALLOW CHILDREN to conduct assembly, as there may be small parts,
sharp edges / sharp points, and packaging material that can present as hazardous.
Ensure proper disposal (and/or recycling, per local laws) of all interior packaging material,
so that they are OUT OF REACH from both children and pets.
It is recommended that you KEEP the original packaging box, in the event that the Blipper
needs to be stored away.
Step one:Installing the handlebar
• Locate the handlebar, handlebar clamps, 10 mm wrench, and 13 mm wrench.
• Position the handlebar so that the accelerator lever is on the right and brake lever
• Place the handlebar directly on top of the bracket behind the headlight.
• Position the top and bottom ends of the clamps onto the center of the handlebar,
so the bottom ends are beneath the handlebar, and the top ends sit directly over
the handlebar. (The clamps are identical, so each one can be affixed on either
side.) The holes in both sets of clamps should align with the holes in the bracket.
• Locate all four handlebar screws and pass each screw through the aligned holes
• Thread each nut onto each screw from the bottom.
• Simultaneously use the 13 millimeter wrench to brace each screw from the bottom,
• Ensure that the handlebar is fully and tightly installed by pulling on it.
There should be no looseness.
•
Disassemble the handlebar clamps, so that all parts - including screws and nuts -
are separated.
is on the left.
from the top.
and use the 10 millimeter wrench to tighten each nut from the top. Continuously
rotate the wrench until all nuts are fully tightened.
To Next Page
Loading...
