2120
Power on (continued)
3) Headlight switch:
The headlight switch is located directly on the bottom of the battery level indicator,
above the accelerator lever on the right side of the handlebar.
To turn the headlight ON, press the headlight switch in.
To turn the headlight OFF, press the headlight switch again so that it’s popping out.
Reminder – the rider should NEVER operate the product at times or in areas of low to no visibility,
including fog, mist, areas with obstructions or blind spots, and dusk / nighttime.
However, in the event more visibility is needed while the product is in use, the headlight switch
can be used to turn on the headlight to increase visibility (to a limited degree).
Note that the headlight switch will NOT turn on the headlight while the product is powered off.
Riding and accelerator lever control instructions
Pre-ride checklist:
Before each use of the product, the rider and any parent or adult supervisor must follow the pre-ride
checklist below.
1) Check the presence, condition, and functionality of ALL PARTS before use, include motor, brake,
battery pack, tires, spokes, headlight, and all other electric parts.
2) Make sure that all of the exposed nuts, screws and bolts are tightened. (Not all required tools may
be provided in the tool kit.)
3) Check to make sure the battery pack is sufficiently charged.
4) Ensure that there are no obstacles or obstructions ahead in the intended riding path.
5) Ensure that there is only ONE rider, who is wearing sufficient safety gear, does not exceed the
maximum weight limit (including any gear/accessories worn), and is using the product in the
presence of parental or adult supervision (if rider is below the age of an adult as defined by law).
6) Ensure that the handlebar is adjusted to a comfortable and appropriate level for the rider.
7) Ensure that the parent or adult supervisor is in possession of the ignition key after each
use of the product.
To Next Page
Loading...
Need help?
General
